This store uses cookies and other technologies so that we can improve your experience on our sites. More information

 close

Filter by

LENGTH
8 mm. 20 mm.
OUTSIDE DIAMETER
16 mm. 50 mm.
WIRE DIAMETER
2 mm. 6 mm.
THREAD
M- 6 M- 12
THREAD MINOR DIAMETER (D1)
11 mm. 38 mm.
THREAD MAJOR DIAMETER (D2)
13 mm. 43 mm.
Home
Best Sellers
RESORTE ARANDELA ONDULADO M10LE4618 Quick view

Reference: M10LE4618

WAVE SPRING WASHER M10LE4618

WAVE SPRING WASHER M10LE4618

THICKNESS: 0.2
NUMBER OF WAVES: 3
FREE LENGTH: 2
OUTSIDE DIAMETER: 18.5
INSIDE DIAMETER: 13
SPRING RATE (K): 29
RAW MATERIAL: CK67
LOAD AT L1: 29
LOADED LENGTH: 1
Price €1.88
More
Muelle de compresion M01MC1940001 Quick view

Reference: M01MCPF4794

Compression spring M01MCPF4794

Compression spring 

FREE LENGTH: 18
OUTSIDE DIAMETER: 4
INSIDE DIAMETER: 3.30
WIRE DIAMETER: 0.35
ACTIVE COILS: 9.39
TOTAL COILS: 11.39
SPRING RATE (K): 0.3
RAW MATERIAL: EN 10270-3 1.4310
ENDS: CLOSED NOT GROUND
SURFACE COATING: NO PROTECTION
SOLID LENGTH: 4.34
Price €3.00
More
Muelle de compresion M01MC4350006 Quick view

Reference: M01MC4350006

Muelle de compresion M01MC4350006

Muelle de compresion M01MC4350006

FREE LENGTH: 8
OUTSIDE DIAMETER: 7.1
INSIDE DIAMETER: 5.70
WIRE DIAMETER: 0.7
ACTIVE COILS: 4
TOTAL COILS: 6
SPRING RATE (K): 2.09
RAW MATERIAL: EN 10270-3 1.4310
ENDS: CLOSED NOT GROUND
SURFACE COATING: NO PROTECTION
SOLID LENGTH: 4.34
Price €3.00
More
copy of Extension spring... Quick view

Reference: M02MCPF4814

copy of Extension spring M02MC20400001

Extension spring M02MC20400001

FREE LENGTH: 54
OUTSIDE DIAMETER: 8
WIRE DIAMETER: 1
ACTIVE COILS: 41
SPRING RATE (K): 0.724
RAW MATERIAL: EN 10270-1 SH
SURFACE COATING: NO PROTECTION
INITIAL TENSION: 4
LOAD LENGHT L1: 85
LOAD AT L1: 26.46
Price €3.00
More
All best sellers
THREAD FITTINGS FOR NO END EXTENSION SPRINGS
THREAD FITTINGS

THREAD FITTINGS FOR NO END EXTENSION SPRINGS

Thread fitting for assembly in compression spring coils, see previous pages. This fitting is safer than conventional
loops, which is why higher loads are permitted on the spring. The coil can be cut into the required length, and
the fitting can be mounted without any special tools. 
The fitting can also be used for compression springs, where the end coils are not ground. Special manufactured
springs with two tightly wound coils at each end must then be ordered.

PDF TABLE OF THREAD FITTINGS FOR NO END EXTENSION SPRINGS

Back to top